I tried to find a post with my problem and couldn't find it. So here it goes.
I'm using serial on the terminal. (Since it doesn't show up on Arduino IDE, as is mentioned here: http://beantalk.punchthrough.com/t/cannot-find-beans-serial-port-in-arduino-ide/3779)
When I upload a sketch and see it on Virtual Serial, it works fine the first time. If I upload another sketch and use it as Virtual Serial, the formatting is all messed up. It doesn't write lines where it should, it overwrites data... It's basically a useless mess.
If I close the Bean Loader and open it again, the problem is fixed. But having to close and reopen Bean Loader every time I make a change to my code makes it a bit inefficient to debug.
Could anyone tell me if it's something I'm doing wrong or if it's a problem with Bean Loader?