I’m having problems with the Bean + (on iOS). All the firmware is up-to-date. The beanloader recognizes the Bean, I can connect and I can upload sketches. However the sketch does not do anything..
E.g. I upload the Blink LED sketch, but the sketch does not run properly (no blinking LED). If I connect a potentiometer and run serial read, the serial monitor does not show anything (even though initilialized properly in the bean loader) However, I can Blink the LED, read the acceleration, etc using the commands (via right click) in the bean loader – just the uploaded code does not work.
The Bean functioned fine so far then we did not use it for 1 or 2 months and now it doesn’t react to any sketch anymore.
Anyone had similar problems?